GeneratorX can be run in standalone mode, which means you can run programs without connecting to a computer. Follow the steps below to learn how to use GeneratorX in standalone mode.
Step 1: Load programs into GeneratorX
Firstly, complete the hardware connection and open Spooky2 GeneratorX.
Open Spooky2 software. Go to Control tab, and you will find two generators that have been detected.
Go to the Preset tab, and choose one Shell (Empty) Preset based on your need. For example, l will choose Healing (R) – JW to help with my bone.
Note: For choosing which shell preset to run, you can refer to this blog: https://www.spooky2-mall.com/blog/how-to-distinguish-healing-and-killing-frequency/
Then, go to Program tab, search the keyword “bone”, and you will find many related programs. Double click or click the “+” button on the programs you want to load. You will see these programs have been added into “Loaded Program” in the lower-left corner. Before you proceed to the next step, check again whether these programs are exactly what you want.
Go to the Control tab, select “Overwrite Generator”. Choose either of the two generators on your GeneratorX. It does not matter if you select generator #4 or generator #5. They both share the same programs. In this example, l will choose generator #4.
Click “Load GX”, you will see a new window pop up.
Below “New Program Name”, give the new program a name so that you can remind yourself what this program is about. If not, it will automatically combine all your program names as titles. Here, l name the program “Bone problems”. Double click on the location you want the program to be stored. You can overwrite an existing program if you like. There are 30 locations which you can store your programs. However, all of these programs should be within the limits of 200 frequencies. Here, l will place them in Location 01.
Now press Save. The “Load Generator box” will close, and the changes will be sent to your GeneratorX. Repeat the above operations, you can download up to 30 programs into one GX.
Click to get more details on how to load programs into GX:
https://www.spooky2-mall.com/blog/how-to-load-programs-into-generatorx/
Step 2: Run programs in standalone mode
After the download is complete, close the Spooky2 software and disconnect GeneratorX from your computer.
Connect Spooky2 Boost and Remote to one generator of your GeneratorX. And then put your DNA sample into Remote.
Press “G1” or “G2” button, and you will see all the programs that have loaded into your GeneratorX.
Use “Up” or “Down” button to select the program you want to run. Here, l will choose “Bone problem”.
Press “Start” button, and you will see that the program is ready on G1.
Then press “Loop” button. “Running” means that the program is running now.
Now, this program will run 24/7 until you stop it manually.
To watch the full instructional video, please click here: How to Load the Program and Run Generatorx Standalone
Hi, I loaded 30 programs on my one generator x , I accidentally loaded 2 the same , how do I unload a program off of the generator? Thanks
Dear Bonnie, yes, you can delete the programs you do not want to. Here it is a video for your reference: https://www.youtube.com/watch?v=aSoUAM5PBNk&t=7s.(How to Delete Programs from Spooky2 GeneratorX) Hope it helps.