You have no items to compare.
Connecting Spooky Boost v2.0
Installing Spooky Boost v2.0
Spooky Boost v2.0 connects directly to OUT1 and OUT2 of your XM generator.
Connect the lead that came with your generator to the Colloidal Silver output of Spooky Boost v2.0. Attach the clips to the 2 silver rods. The rods should be approximately 1 inch apart. Full instructions can be found in the Spooky User's Guide.
Connect your Hand Cylinders or TENS pads to the Colloidal Silver output of Spooky Boost v2.0. The output power is reduced to make contact mode very safe.
Spooky Boost (Bio North)
Spooky Remote BN connects directly to the BN output connector of Spooky Boost v2.0.
Spooky Boost (Magnetic North)
Spooky Remote MN connects directly to the MN output connector of Spooky Boost v2.0.
Spooky Boost v1.0
You may attach Spooky Boost v1.0 to Spooky Boost v2.0 using the 2 top OUT1 and OUT2 connectors.
Spooky Remote BN – Blue to OUT1. Red to OUT2.
Spooky Remote MN – Red to OUT1. Blue to OUT2.
You can run 2 boosted remotes simultaneously. This is not recommended. The performance will be reduced for each remote. Do not run Spooky Remote BN and Spooky Remote MN from the same generator.