Chat with us, powered by LiveChat
Dark Light

How to Set Preset Chain in Three Different Scenarios Leave a comment

Share this:

Spooky2 software is very versatile. It not only provides factory preset chains for your ease of use, but also allows you to create your own preset chains. Here, you can follow the instructions to set preset chain in three different scenarios.

Scenario 1
If you just want each preset in the chain to run once:

Repeat Sequence = 1
Repeat Chain = 0

Scenario 2
If you want each preset in the chain to run for a period of time (say 24 hours):

Repeat Sequence = 0
Repeat Chain = 0
Run For = 24

Scenario 3
If you want each preset in the chain to run for a period of time, but not while you sleep:

Repeat Sequence = 0
Repeat Chain = 0
Run For = 24
From From = 07:00 am
Run to = 11:00 pm

Note:
1.When you make the changes of settings, you need to do this for every preset in the chain.
2.To do this, you need to run the latest version of ChainEditor. The latest version of Spooky2 software (20180601) will put a copy of the ChainEditor installer called ChainEditor.msi in C:Spooky2. If ChainEditor was previously installed, uninstall the old ChainEditor in the Control Panel in the Add/Remove software panel.

Thanks for Bryan Yamamoto
Source: https://www.spooky2.com/forums/viewtopic.php?f=5&t=9683

Share this:

Leave a Reply

Your email address will not be published. Required fields are marked *

Mini Cart 0

Your cart is empty.