How to Use Spooky2 Rife for Frozen Shoulder 4

Frozen shoulder refers to gradual stiffness and pain in your shoulder joints. It affects about 5% of people worldwide, especially those between the ages of 40 and 60.

What can cause a frozen shoulder?

Hormonal imbalances, diabetes, a weakened immune system, or chronically restricted shoulder motion can all lead to frozen shoulders. Studies have shown that people with diabetes are three times more likely to develop frozen shoulders.

If you have neck and shoulder pain, limited mobility around the shoulders, swelling, or stiffness, these symptoms may also indicate you have frozen shoulders.

Our Spooky2 user Manuel Mallo had great success with Frozen Shoulder.

Two years ago, he had terrible pain in his left shoulder. The pain was making his life miserable. He was even unable to sleep.

Then he tried the presets he created (especially in contact mode) and did a liver cleanse (using Dr. Hulda Clark’s method). After a couple of months of slow but continuous improvement, the pain completely disappeared. Now he is still pain-free.

He used the contact preset once daily and the Remote preset 24/7 for 2 months. Every other day, he also used the preset for Staphylococcus Aureus, which is included in Spooky2 software now.

You can download the presets for Frozen Shoulder created by Manuel Mallo from here:

MM_Frozen Shoulder(C).txt

MM_Frozen Shoulder(P).txt

MM_Frozen Shoulder(R).txt

So extract the file inside the archive and copy it into the user folder (C:\Spooky2\Preset Collections\User).

While running the Frozen Shoulder presets, the Plasma preset must be used without using the Boost or altering the settings unless you know perfectly what you’re doing.

Contact and Remote presets should be used with the Boost to achieve the harmonics intended. If you use TENs pads, use the big ones to prevent skin burns because the contact mode preset uses a 100% offset waveform. Don’t place the TENs pads over the painful area. Put them on your elbow and your scapula. Anyway, hand cylinders are preferable for this preset.

The contact mode preset could be uncomfortable. You can lower the amplitude (voltage), but it is not recommended, as the effectiveness decreases.

Monitor carefully any adverse effects, and if there are reactions to any frequency, you can repeat them.

Hope these presets will work for you!

Thank you, Manuel Mallo, for creating these presets!