The True Amplitude Modulation Preset 2

John has created a contact-mode preset which provides the true amplitude modulation with a fixed carrier.

Quite a lot of people get fixated on the idea of using a fixed carrier, and applying what they term the “Hoyland Sweep”. This preset allows them to do this in Contact mode, without having to spend a dime on additional hardware.

Some people have created expensive hardware which does a similar (albeit inferior) function. They use the terms ‘Bendini’ and ‘Pump Wave’ to colorfully describe their basic Amplitude Modulating device. A signal generator is still required.

GeneratorX has all these functions built-in, so no additional hardware is required. As a bonus, the GX signal is cleaner, because pure sine waves are used.

The True Amplitude Modulation (GX) (C) – JW preset has a fixed 3.1 MHz carrier. If you require a different carrier frequency, simply alter the Out2 frequency in the Settings tab.

The preset will only work correctly with GeneratorX. The XM generator does not have a built-in modulation function.

This is a ‘Shell’ preset. You must choose your own programs before running.

Because a very high carrier frequency is used, you will not feel any sensations. Our bodies are unable to detect frequencies higher than around 20 kHz.

Important:
1. Connect your TENS Pads or Spooky2 Hand Cylinders to the ‘Out1’ port of Spooky2 Boost. It is important to NOT use Out2 because the signal from Out2 defines the carrier signal.

2. Do NOT use the ‘High Power’ or ‘CS’ ports.

3. Do not use it with the BP, DNA, MW, or BFB scan results. Amplitude Modulation uses a high-frequency carrier along with lower frequency modulating frequencies. BP, DNA and MW database entries are already subharmonics of much higher frequencies, so a low-frequency modulation is very undesirable. Modulating a carrier wave with an octave subharmonic will almost certainly miss the fundamental of very high frequencies.

4. Stop treatment if you experience any discomfort.

Using This Preset

Step1: Download this shell preset here: https://www.spooky2-mall.com/download/TrueAmplitudeModulation(GX)(C)-JW.txt.zip

Step2: Extract the file, and put this document in the Local Disk(C:) > Spooky2 > Presets Collections > User folder.

Step3: Open your Spooky2 software. You can find this preset under C:\ Spooky2\ Presets Collections\ User.

Step4: Choose this Shell preset. Go to the Programs tab and choose the programs you need.

Step5: Go to the Control tab and tick “Overwrite Generator”. Choose your generator port, and start your treatment.

For more details, please check this video:

Did you try this preset? How do you feel? Comment below and share your experience with us.

Related Blogs:
Will Two Same Frequencies at Same Settings Cancel Each Other Out?
An Improved Method of Applying Frequencies